Dryer Problems We RouteWhat the Independent Dryer Pros Fix
Dryers are simpler than they look: a motor, a drum, a heat source and a path for air to leave. When one of those fails, the symptom usually tells a trained tech where to start.
No Heat, ElectricHeating Element, Thermal Fuse and Thermostats
Electric dryers lose heat when the element coil breaks, the thermal fuse or thermal cut-off opens, or the high-limit or cycling thermostat fails. A half-tripped 240-volt breaker can do the same thing, drum turning and no warmth. The tech meters each part in the heat circuit and checks voltage at the terminal block.
- Heating element replacement
- Thermal fuse and cut-off testing
- High-limit and cycling thermostats
No Heat, GasIgniter, Gas Valve Coils and Flame Sensor
A gas dryer heats a glow bar, then the valve coils open to release gas onto it. Igniter glowing with no flame usually means weak valve coils. No glow at all points to the igniter itself or the flame sensor. Each component gets a resistance check, and the technician confirms supply pressure at the valve with a manometer.
- Glow bar igniter replacement
- Gas valve coil sets
- Flame sensor testing
Thumping and SquealingDrum Belt, Idler Pulley, Rollers and Glides
A rhythmic thump usually comes from flat spots on the drum rollers. A high squeal points to a dry idler pulley, and a scraping sound often means worn front drum glides or a felt seal that has slipped. A snapped drum belt leaves the motor running with the drum dead still. The tech pulls the drum and replaces wear parts as a set when they are close to the same age.
- Drum belt and idler pulley
- Drum rollers and axles
- Front glides and felt seals
Long Dry TimesRestricted Vent Run and Airflow
More dryer calls trace back to the vent than to any failed part. A crushed foil transition hose, too many elbows, a run longer than the manufacturer allows, or lint packed at the wall or roof cap chokes airflow, so loads take two or three cycles. The tech checks exhaust temperature and airflow at the cap, then recommends rigid metal duct where needed.
- Vent airflow testing
- Transition hose replacement
- Wall and roof cap lint clearing
Stops Early or OverdriesMoisture Sensor Bars and Auto-Dry Controls
Auto-dry cycles read moisture through two metal sensor bars inside the drum. Fabric softener film coats them, and the dryer shuts off while clothes are still damp. A faulty board or harness can do the opposite and run forever. The tech cleans the bars, tests the circuit and checks the control.
- Moisture sensor cleaning and testing
- Control board diagnosis
- Timer and cycle selector checks